![]() Observe the basic rules of concrete work. Never mix with cement or additives other than SCHÖNOX approved product.Mix in a well ventilated area and avoid breathing powder or dust. In case of contact with eyes seek additional medical advice. In case of contact, rinse immediately with plenty of water. SCHÖNOX US contains Portland cement and sand aggregate.Empty packaging and dispose of in accordance with federal, state, and local waste disposal regulations.End of shelf life does not generally indicate the end of the products suitability for the intended use.Low substrate temperatures and/or high ambient humidity require longer drying times.As floor coverings vary, always contact and rely upon the floor covering manufacturer for specific directions such a maximum allowable moisture content, adhesive selection, and intended end use of the product. Always install an adequate number of properly located test areas, to include the finish flooring, to determine the suitability of the product for its intended use.Protect curing SCHNOX US layers from high ambient temperatures, direct sunlight, and draughts.The second layer must not exceed the layer thickness of the first layer. The maximum layer thickness must not be exceeded in case of two layer applications. If a second layer of leveling compound is to be applied, prime the first layer with SCHNOX KH FIX after drying.Contact to vertical structures should be avoided by putting in SCHÖNOX FOAMTAPE.In higher thicknesses using a pike roller is recommended. Even surfaces are easily achieved using a pin leveler. Then pour the mix and spread using a smoothing trowel. Using a clean mixing drum, add SCHÖNOX US to cold, clean water to form a homogeneous mixture.Do not overwater! Foam while mixing, or settling of the sand aggregate while placing, indicates overwatering.As qualities of locally available aggregates vary, we recommend to perform tests prior to use on a larger scale: ![]() we recommend to extend SCHÖNOX US with dry, clean aggregate (aggregate is added last) at a layer thickness above 1.5": Type and amount of aggregate used will affect product performance.gypsum substrates such as (sanded and vacuumed).old water-resistant adhesive residues, removed as far as possible.non porous, smooth, sound substrates such as:.old substrates such as ceramic tiles and terrazzo.OSB board, plywood (well screwed down or bonded) prior to install flexible coverings.under interior wood floor, layer thickness at least 1/4"Īs well as for filling, smoothing and leveling of unheated, cement based substrates under:.SCHÖNOX US is suitable for filling, smoothing and leveling of substrates:
0 Comments
Leave a Reply. |